Site designed by ProActive Design

FAQ | For sale | Home

Wetbike

One time out on Wetbike is one time to remember. The watercycle sits squarely in the water. Get behind is, grasp the handles and get the feel. With one good skootch you should be able to slide up into the saddle. Keep your balance. Turn the electric start. And gently open the throttle.

The 50 h.p. Spirit jet drive magnificently propels you to the surface, water beads glistening in the sun. And it does it without any propeller. The jet stream of water is backed by 723 cc's of factory tested Spirit power. Plus reliable Mikuni carburetors, super efficient reed valves and low maintenance CD ignition. Enough power to ride single or two up. Or even to pull a water skier.

You handle Wetbike like a motorcycle. Lean into turns, respond to the feel and Wetbike responds right back. To come to a stop, ease up on the throttle and Wetbike settles gently into the water again. It does the same if you take a spill, with a safety tether switch and spring loaded "off throttle".

Wetbike launches anywhere boats can and even where boats can't It trailers and unloads just like a boat or wheels across the sand on the two wheeled Beach Buddy.

Wetbike Design

How to get on a Wetbike

Wetbike Specifications

1985

  • Overall Length 7.5 ft.
  • Overall Width 2.0 ft.
  • Hull Length 6.0 ft.
  • Overall Height - Hull & Skis 3.5 ft.
  • Hull Height 2.5 ft.
  • Overall weight (unfilled) 350 lbs.
  • Floatation Capacity 600 lbs.
  • Engine Type Two-Cycle Water-Cooled Gasoline Engine
  • Intake System Reed Valve
  • Maximum Horsepower 60 HP @ 5400 rpm
  • Jet Pump Flush Inlet, Axial Flow
  • Impellor Size 7.3 x 4.5 in.
  • Bilge Pump, Electric Constant On When Ignition Switch is On
  • Battery 12 volt 32 AMP/HR Marine Type
  • Steering System Handlebars and Rotatable Front Ski 90 degrees Pivot
  • Maximum Speed 32 mph
  • Achieve Planing Speed 11-15 mph
  • Draft 2.5 ft./ Stationary Planing 4.0 in..
  • Driver Safety Stop Switch Positive Stop Throttle and Tether Switch
  • Starter Fuse In-Line In-Line 20 AMP 20 AMP
  • Bilge Pump Fuse In-Line In-Line AGC-2 AGC-2

1986 & up

  • Overall Length 7.4 ft.
  • Overall width 2.0 ft.
  • Hull Length 5.93 ft.
  • Overall Height - Hull & Skis 3.45 ft.
  • Hull Height 2.45 ft.
  • Overall weight (unfilled) 317 lbs.
  • Floatation Capacity 600 lbs.
  • Engine Type Two-Cycle Water-Cooled Gasoline Engine
  • Intake System Reed Valve
  • Maximum Horsepower 60 HP @ 5400 rpm
  • Jet Pump Scoop Inlet, Axial Flow 
  • Impellor Size 7.3 x 4.5 in.
  • Bilge Pump, Electric Float Switch Operated
  • Battery 12 volt 32 AMP/HR Marine Type 
  • Steering System Handlebars and Rotatable Front Ski 90 degrees Pivot
  • Maximum Speed 36 mph
  • Achieve Planing Speed 11-15 mph
  • Draft 2.5 ft. / Stationary Planing 4.0 in.
  • Driver Safety Stop Switch Positive Stop Throttle and Tether Switch
  • Starter Fuse In-Line In-Line 20 AMP 20 AMP
  • Bilge Pump Fuse In-Line In-Line AGC-2 AGC-2

Wetbikes' for sale  |  Wetbike history pictures